| This photograph was taken while marking the fourth increment on the projected 3D line. The laser dot
is falling on the edge of the profile and on the paper on the fuselage. The process of projecting and marking
the 3-D line is amazingly simple :
Move the fuselage along it's front-rear axis in some convenient increment (say, 1/2"), raise the laser until the
dot once again lies on the edge of the profile and the paper on the fuselage, and mark a dot on the paper.
Move the fuselage, raise the laser, mark the dot. Move the fuselage, raise the laser, mark the dot.
Simple ? Yup. Gets even easier from here on out . . .
|
