|
The box was built to fit the original foam wing core husks. There is an upper and lower
compartment, where the two wing panels are stored.
The only part not obvious is a partition dividing the upper and lower compartments.
The handles are attached through the side panel and into that divider.
The wings go in their respective compartments "up", that is, when the compartment is
opened you're looking at the top of the wing panel.
In this view a slot can be seen in the bottom foam husk, about half-way along the length of the box.
That slot is to accomodate the external aileron control rod in the wing.
The two notches in the left end of the foam are where the spar stubs locate in the foam husk.
|
